WTP movie

H2o transfer printing movies include a transparent layer of polyvinyl alcohol (PVA), which can be printed using a selection of decorations. The ink layer is then sealed. The PVA layer dissolves on contact with water. Thereafter, the seal is dissolved by an activator (a specific type of solvent) and just the colour layer continues to be. The paint layer adheres on the workpiece immersed and behaves like a lacquer layer following drying.

The best h2o temperature to the strategy of printing h2o movies is 32 ° C. In cold climate as much as 34 ° Celsius.

The transfer water transfer film needs to be lower on all sides in a distance of 1 cm to prevent winding when positioning on the surface area from the water. You should do not stick with tape simply because the film can not increase throughout the immersion method (If the PVA is dissolved, the movie "relaxes" and the surface area size raises minimally).

Following the desired exposure time, spray the film in a length of 20-30 cm inside the path of crossover with activator of twenty five to 45 g / m² (depending on the purpose, given that hugely printed films need to have much more activator).

The workpiece can be immersed following approx. fifteen seconds.

All components that are not made of Ab muscles plastic must be geared up just before diving (eg by lacquering).

Following approx. One particular moment, the workpiece must be washed with very hot drinking water at 42 ° C (usually do not make use of a powerful h2o jet, parts of the film might dissolve).

The coloration demonstrated might differ through the first movie depending on the output unit. For a outcome which is akin to the image, the colour advice track record should match the selected drinking water transfer print movie.